Whitetails Unlimited TaxidermySouthern Junkey
Results 1 to 3 of 3

Thread: .308 Brass

  1. #1
    Join Date
    Oct 2010
    Location
    SW GA
    Posts
    9,269

    Default .308 Brass

    Whew! Getting ready to run this NATO RA 69 head stamped brass. Anybody wanna help? Can't decide whether to anneal it first or after I size and clean it. Looks like one got away!
    Yippee Ki Yay

  2. #2
    Join Date
    Feb 2009
    Posts
    2,045

    Default

    You loading it for match shooting or plinking? Hope you don't have to remove a crimp like on .223's.

  3. #3
    Join Date
    Oct 2010
    Location
    SW GA
    Posts
    9,269

    Default

    yes it has a crimp like .223. They have all been sized with the shoulders pushed back to -.002, Primer pockets were swaged, they were trimmed, neck sised again, and then cleaned in the cement mixer to get the lube off. They pretty much ready to load. I think I am going to sell them. For the most part they are all NATO stamped Remington Arms 69...I can post a pic of the headstamp. There may be something else in there but they are hard to find...thought about sealing them up in 100ct food saver bags to get a good count...might just weigh them for approx counts.

    They were finished about a week after that picture.
    Yippee Ki Yay

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •